As we all know, there are many types of lamps, different types of lamps have different shapes, and there are certain differences in installation and disassembly methods. Ceiling lamps are frequently used in bedroom decoration, and different types of ceiling lamps have different shapes, so it is more troublesome to disassemble the lampshade.

1. Cover of Round LED ceiling panel light: Before dismantling, we need to cut off the power switch of the lamp. The safety of disassembly can only be guaranteed after we cut off the power supply. Since the circular ceiling light can only be opened normally by rotating the chimney, we need to use a screwdriver to slowly pull down the small screw iron ring around the chimney. When the chimney is loose, it can be rotated. We only need to rotate the chimney until the screw is unscrewed. After Z, remove the chimney.

2. Embedded ceiling light: Since this light is directly installed with the integrated ceiling, there seems to be no place to start when dismantling it. In fact, it is not difficult to remove the lampshade of this kind of lamp. The recessed ceiling light is trapped in the ceiling. Before we put the chimney, we also need to cut off the power first, and pull down the underside of the ceiling concave-convex board. Next, if you look closely, you will find that the recessed ceiling light has a spring clip and it is stuck. , we only have to interrupt it.

3. Aluminum gusset ceiling lamp: For this type of lamp, if we directly use the rotation method, the lampshade cannot be disassembled. The correct method should be to turn off the power first, then use a small screwdriver or a small thin-blade aluminum gusset to move the light at the corner of the Hamming cock, and any section of the gusset can move the light. You can see on the ceiling light that there are two similar tubes. Then we can use two pieces of hard plastic to insert the edge of the gusset plate, move the card to the other side, and at the same time pry down a little bit to open a gap, then pull out the gusset plate by hand, take the Go down the chimney.

4. Rectangular ceiling lamps: Compared with circular lamps, such lamps will be more troublesome to disassemble. First we need to cut off the power and then find the four corners around the light. We can borrow the washing hook of the glass suction cup, pull it to the aluminum alloy part of the side, and slowly pull down, every corner, until the lampshade is removed. In the process of pulling, we should move slowly and do not use too much force, so as not to damage the lamp directly or again.