With the opening of the lighting market, the Led Panel Light appears repeatedly in our days. This is a piece of electroluminescent semiconductor material. It has the advantages of high efficiency, energy saving, environmental protection and long service life. Then the led light will not turn on after a long time. How to solve?

In this case, try replacing the light bar first. If the light strips are connected together, pay attention to the replacement process, pull the light strip down and replace it with a new one. If the Led Panel Light is on, it proves the power of the panel light. If it still doesn't light, try replacing the Led Panel Light power supply from scratch. However, when repairing LED lights, be sure to disconnect the power first to protect yourself.

How to install Led Panel Light

First, there is a device hole on the base of the flat light to the position where the device is needed, and use a pen to draw the position of the screw hole on the wall. Punch holes in the markers, start screwing the base of the device, and arrange the screws on the retaining clips until the flat light reaches the proper lighting angle.

Led Panel Light Device Precautions

The area of ​​the flat light device must have a strong receiving capacity and must accept more than 10 times the weight of the driver. The power supply for the panel light operation must be high voltage AC, so do not place it in an area where people are easily touched, and the panel light should be grounded and grounded.

Since Led Panel Light is a power device, it is more flexible to ambient temperature. When the temperature is too high, its lifespan will be significantly shortened, and there will be serious signs of light decay. Therefore, the flat light should be placed in a ventilated place and have a good heat dissipation environment.